WIKA Model BLR Reed sensor For bypass level indicators
2015-06-17 23:49:16
Description:
Model BLR Reed sensor For bypass level indicators……
New Products
Orbinox VG SERIES 61 Slurry knife gate valve
Orbinox SERIES 61 (VG) model knife gate valve is a wafer type valve equipped with two metal reinforced rubber sleeves,designed for applications with abrasive slurries.
Crosby J-Series Direct Spring Pressure Relief Valves
J-Series valves provide high quality and dependable overpressure protection for air, gas, steam, vapor, liquid and two-phase applications in one simple design. Now available with two new to the world technologies, Balanced Diaphragm and Bellows Leak Detection.
Vanessa Series 30,000 Cryogenic Triple Offset Valve
The Vanessa Series 30,000 Cryogenic Triple Offset Valve is a virtually maintenance-free valve with tightness, operability and torque demand unaffected by cryogenic conditions and severe temperature fluctuations.
Sempell Model SOT High pressure steam safety valve
The Sempell Model SOT is a high-pressure steam safety valve designed for boiler protection and steam system safety.
Assortments
Description
Applications
Sensor for continuous level measurement of liquids in bypass level indicators
Chemical and petrochemical industries, oil and natural gas extraction (on- and offshore)
Shipbuilding, machine building
Power generating equipment, power plants
Pharmaceutical, food, water treatment, environmental engineering industries
Special features
Installation of head-mounted transmitters in the connection housing possible
Various contact separations selectable
Programmable and configurable head-mounted transmitters for field signal 4 ... 20 mA, HART®, PROFIBUS® PA or FOUNDATION™ Fieldbus
Explosion-protected versions
Temperature ranges from -100 … +350 °C
Description
The model BLR reed sensors are used for continuous monitoring and recording of the liquid level in connection with transmitters. They work on the float principle with magnetic transmission (permanent magnet, reed switch and resistance measuring chain) in a 3-wire potentiometer circuit.
A magnetic system built into the float actuates, through the walls of the bypass chamber and of the sensor tube, reed contacts at a resistance measuring chain (potentiometer). The measurement voltage generated by this is proportional to the fill level.
The resistance measuring chain is made up from reed contacts and resistors soldered onto a PCB. Depending on requirements and design several different contact separations from 5 to 18 mm are available.
For selecting the optimum sensor (sensor model, connection housing, electrical connection, sensor tube (material and total length), contact separation, head-mounted transmitter, measuring range, approval) we offer application-related technical advice.